Only Trap Box Belisle 120

Item ID: 121280

387 kr
  Buy
Available
Not available
.
Not available

 

ecster_summer16

 

 

Z-aim X-Box

Our own new box for Belisle 120x gives you a number of advantages:

No springs that protrude to the sides and make it difficult to mount in the tree etc.
The loaded trap is easily inserted into the box.
The trap is locked firmly internally, making both vertical and horizontal mounting effective and catchy.
Ready-made mounting points for mounting with belt.
Plenty of space for litter material.
Sides / covers and caps made of water resistant plywood without lacquering means that the box can be treated by burning, ironing with blood or whatever you prefer. Remaining parts of latex pine.
Inlet hole with approved dimensions for mower 90mm.
Mounting trap in box:

Adjust the gillers in the trap as you think by breaking apart.
Tighten the springs on the trap and secure them. (Use go-ahead input)
Tighten the throat thread the last piece by hand and fit the gill into the outer hack. (Please attach an optional accessory fuse to the impactor)
Fold the springs against the gripping sides against the gill (Secure impact spring on the side where the fuse ends between the impact spring and the gripping needle)
Stick the square stick through the rings of the springs (The edges of the spine may need to be tipped off). The gill should now be placed closest to the square stick.
Put the trap inside the box and push the threaded wire brackets on the outside to the thin rule at the bottom. (If you want to mount the gill at the bottom of the trap, remove the corresponding gill of the rule)
The square stick is provided with recesses that should be on the inside of the box when the trap is completely down.
Clear the trap firmly, put on the lid and turn the loops.
Tip:

As an accessory to Belisle 120X, there are:
Vajerutlösare (thin wire that is inserted from one thread wire to the other)
Trampgill plate easily mounted on existing gills.
Voltage (Lilla) that simplifies charging and reduces damage risk.
Extra pressure fuse that is easily put over the impact braces on tension trap and prevent it from striking if you happen to be negligent.
If you want to wrap your trap easily, buy a pint of beef and paint it inside / outside. Inside is far enough.

If you want it to melt well into the environment, you can burn the box outside with a gas burner.

To keep in mind when installing a trap: The location should be 1.5m above ground to prevent the wrong animals and, in the worst case, children from accessing it.



Bookmark and Share






Skriv recension

Categories
Customer's Area