This rail is CNC machined from 7075 / T6 Aluminum to get a base that has high strength and is lightweight. It has a hard-lacquered anodized surface to reduce abrasion and get higher corrosion resistance. It is also equipped with self-centering tapered T-15 Torx screws.
Installation instructions:
Check around and in the screw holes so it's clean from the slack.
Remove oil and grease around the screw holes and contact surface.
Place the base of the weapon and make sure you have the right fit and adjustment.
Screw your screws loosely.
Once you get the correct position on the rail, tighten the screws tight.
(Warne recommends using a removable locktight for best results)
This rail is CNC machined from 7075 / T6 Aluminum to get a base that has high strength and is lightweight. It has a hard-lacquered anodized surface to reduce abrasion and get higher corrosion resistance. It is also equipped with self-centering tapered T-15 Torx screws.
Installation instructions:
Check around and in the screw holes so it's clean from the slack.
Remove oil and grease around the screw holes and contact surface.
Place the base of the weapon and make sure you have the right fit and adjustment.
Screw your screws loosely.
Once you get the correct position on the rail, tighten the screws tight.
(Warne recommends using a removable locktight for best results)